Home > Not Working > Usb Wifi Adapter Not Working

Usb Wifi Adapter Not Working

Contents

In the last two hours I have not received any disconnects but I still see packet loss sporadically within the two hours even though the box is idle. Sheldon Cooper, Ph.D. drivers) are currently loaded. Index User list Search Register Login Skip to forum content OpenWrt Wireless Freedom wifi command not working on 14.07 and RaLink rt5370 OpenWrt →General Discussion →wifi command not working on 14.07 have a peek here

Reason: doubling up Adv Reply December 3rd, 2012 #6 triugan View Profile View Forum Posts Private Message First Cup of Ubuntu Join Date Dec 2012 Beans 8 Re: Ralink RT5370 I have gone inside this folder: ~~~~~~~~~~~~~~~~ Desktop/RT5370/os/linux I have opened config.mk here and set two lines to y (yes): ~~~~~~~~~~~~~~~~~ HAS_WPA_SUPPLICANT_SUPPORT=y HAS_NATIVE_WPA_SUPPLICANT_SUPPORT=y If somebody can explain why the user has Look under wireless and note the driver. If that's the case, let's load it and see what happens: Code: sudo modprobe rt2800usb iwconfig sudo iwlist wlan0 scan Thanks. "Oh, Ubuntu, you are my favorite Linux-based operating system" --Dr.

Usb Wifi Adapter Not Working

Airplane mode is marked as OFF with the grey background. Is there something I should be looking for? Both are marked ON with the orange-background ON switch. On the same Raspberry Pi, I also tried another RT5370 with built-in antenna (one of these ultra small devices) and it worked, even though it would only see 3 access points,

Two of those are in my house and the laptop reports full signal strength. Exit from root account: [email protected]:/etc/wpa_supplicant# exit [email protected]:/etc/wpa_supplicant$ Now we need to stop wlan0: sudo wpa_action wlan0 stop Then load it back up with the new wpa config: sudo ifup wlan0 After It looked like a hardware problem was unlikely. Usb Wifi Not Working Windows 7 When you have decided and placed the non-starter far away, please insert your favorite and post: Code: lsusb cat /etc/network/interfaces cat /etc/udev/rules.d/70-persistent-net.rules dmesg | grep -e wlan -e rename -e rt2

I prefer the RY5370 because it is generally cheaper and is available with an external antenna (see below for a bit of a warning though...) 1. Usb Wifi Adapter Not Detected How to improve player engagement in video call for virtual tabletop game? I'm not afraid to do what I have to do as long as it's explained clearly and/or assumes no prior knowledge. WPA Supplicant implements WPA key negotiation with your router using configuration information stored in a text file /etc/wpa_supplicant/wpa_supplicant.conf.

Check and make sure your wifi dongle has installed correctly (LSUSB): lsusb This will list all the connected USB devices. Wifi Adapter Not Working Windows 7 Wifi doesn't work! (hard blocked: yes,soft blocked :no, hp pavillion g6 2237, Ubuntu 12.04)?0Belkin N600 USB Wireless adapter on Ubuntu 14.10 problem?1Cannot get my N300 (DWA-130) D-link wireless USB to work Basic Optical Mouse v2.0 Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 002 Device 001: ID This is exactly what I get.

Usb Wifi Adapter Not Detected

Thanks again for your help. However, during normal setup it definitely detects the wireless adapter (the only one on this system). Usb Wifi Adapter Not Working See the man pages athttp://netbsd.gw.com/cgi-bin/man-cgi?wpa_supplicant.conf+5+NetBSD-current You do not need to read the man pages unless you are really interested, we are going to walk you through editing the wpa_supplicant.conf file. Usb Wifi Adapter Not Connecting To Internet I was reading through various web resource and finally followed the following steps as described in one of the posts.

I thought it was my ISP as well as I usually notice this at night when I'm streaming some video but with the monitoring application that I have in my home navigate here I don't know why. For example, this is the command line and the program's response on my RPi: [email protected]:~$ sudo wpa_passphrase YOURSSID "Your passphrase" network={ ssid="YOURSSID" #psk="Your passphrase" psk=8dda9088c5dad96bd95b86d76353151fa5376418d12eb0ceee9ddbc26a46a74c } [email protected]:~$ The easiest way to Open the terminal: apt-get install linux-headers-generic build-essential gksu gedit /etc/udev/rules.d/95-RT5370.rules A new empty document will open. Wireless Usb Adapter Not Working Windows 7

  1. RT5370 Wireless Adaptor" bit you need to see!You can also use(LSMOD)lsmodThis shows which kernel modules (e.g.
  2. Have you tried running a wifi scanner to see what other AP's are on what channels in your area ?
  3. There appears to be no easy way (or obvious way) to scan for networks in a GUI-type thing, too.
  4. Code: sudo modprobe rt2800usb I'm asked to enter my password.
  5. If they're there - then they're working :) It should look something like: rt2800usb 14940 0 rt2800lib 55351 1 rt2800usb rt2x00usb 11215 1 rt2800usb rt2x00lib 42335 3 rt2x00usb,rt2800lib,rt2800usb mac80211 273413 3
  6. Fascinating.
  7. After pulling whatever hair I had left (admitedly not that much), while trying to convince myself it was useless, I swapped the WiFi dongle to another model.
  8. rename3 IEEE 802.11abg ESSID:off/any Mode:Managed Access Point: Not-Associated Tx-Power=0 dBm Retry long limit:7 RTS thr:off Fragment thr:off Power Management:on It's Wlan1 instead of wlan0 because I since I last wrote I've
  9. Otherwise some logs will be best way to pursue this Sam javi1r 2015-09-04 13:55:36 UTC #3 Thx Sam, not following you on the statement if it is working already then the

Edit /etc/network/interfaces: cd /etc/network nano interfaces Change it to look like this: auto lo iface lo inet loopback iface eth0 inet dhcp auto wlan0 allow-hotplug wlan0 iface wlan0 inet dhcp wpa-conf Tango Icons Tango Desktop Project. We suspect rt2800usb. "Oh, Ubuntu, you are my favorite Linux-based operating system" --Dr. Check This Out It looked like everything was setup properly and yet, there was no connection.

Anyway, if I should be looking for some particular files I need, please let me know where I can find them. Usb Wifi Adapter Not Working Windows 10 wlan1 IEEE 802.11bgn ESSID:off/any Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm Retry long limit:7 RTS thr:off Fragment thr:off Power Management:on eth0 no wireless extensions. more hot questions question feed about us tour help blog chat data legal privacy policy work here advertising info mobile contact us feedback Technology Life / Arts Culture / Recreation Science

You're looking for the rt2800usb, rt2800lib etc.

I have plans to improve our DVB and Wireless firmwares so this may improve later this month. From the driver/software/settings on the adapter I have not done any troubleshooting as I'm not familiar how to troubleshoot this from the OSMC box. modules. Usb Dongle Not Detected Simply add the following (no spaces between network={):network={ ssid="" psk="" }Once you have edited the

Because not every Linux distribution uses or includes NM, Ubuntu Server Edition for example. physical id: 1 bus info: [email protected]:05:01.0 logical name: eth0 version: 10 serial: (snipped) size: 10Mbit/s capacity: 100Mbit/s width: 32 bits clock: 33MHz capabilities: pm bus_master cap_list ethernet physical tp mii 10bt It puzzles me that two devices with external antennas would not "see" anything while another using the same chipset but a microscopic internal antenna would work much better. this contact form Is it a thumb size adaptor or one of the tiny micro ones that only sticks out a few millimetres ? (which have very small antennas and poor range/performance) IMHO the

Adv Reply Page 1 of 2 12 Last Jump to page: Quick Navigation Networking & Wireless Top Site Areas Settings Private Messages Subscriptions Who's Online Search Forums Forums Home Forums It has been known to cause random problems like disconnection. Ubuntu Logo, Ubuntu and Canonical Canonical Ltd. WPA is not built-in or enabled...why?

Join them; it only takes a minute: Sign up Here's how it works: Anybody can ask a question Anybody can answer The best answers are voted up and rise to the What's the meaning of 'Cronenbourg' in the Rick and Morty episode Rick Potion No. 9? It turns out that the two dongles that I tried first (both RT5370 with external antenna) are extremely hard of hearing and they did not see any of the 7 (seven!) your Device Number and ID will vary, it's the "5370 Ralink Technology Corp.

When I run the lsusb command, following is the output. Adv Reply December 3rd, 2012 #2 chili555 View Profile View Forum Posts Private Message Ubuntu Member Join Date Aug 2005 Location South Carolina, USA Beans 22,689 DistroUbuntu Development Release Re: Browse other questions tagged wireless networking drivers ralink or ask your own question. Fair enough.

How far and through how many walls are you trying to connect ? Odd, indeed! It is clear to see that there are some conflicts going on here. The configuration file for WPA Supplicant requires an encrypted version of your network passkey.

I checked all the places on the net that had info about this problem to no avail. You're looking for the rt2800usb, rt2800lib etc. So from the network point of view yes I have done some troubleshooting. Note.

Truly odd... Truly odd...